200 Series Dual Monitor Arm The interlocking design of the 200 Series provides telescoping adjustment. Easily extend or retract your monitors through a 23" (58 cm) range of motion. The Dual Wall Mount allows you to position two LCDs at the point of need, then push them back out of the way when not in use.
Features & Benefits:• Touch-screen stability
• Cable management system routes and conceals cables under the arm
• Rotate screens to view in either landscape or portrait mode
• Accommodates various display sizes; slide screens into place to align edges
• Rugged, durable, easy-to-clean powder-coated painted steel exterior
• Extends out 23" (58 cm) or folds back to 5.7" (14.5 cm) from wall in storage position
Specifications:• Includes wall mount bracket, 2 extensions, crossbar and 2 sliding LCD mounts, VESA mounting screws
• Maximum outside width of display is 22" (56 cm), the typical horizontal dimension of a 22"-diag. screen monitor
• Weight Capacity: 13 lbs per mount; 26 lbs total. Note: Monitors must be equal in weight or +/- 1 lb
• Monitor depth greater than 3" (7.5 cm) may diminish capacity
• Install display mounts on the bow at +2.5° or -2.5° angle to optimize viewing conditions
• Monitors are installed with 8° inward off-set angle, creating a 16° viewing parabola for better sight lines
• Mounting Standards: VESA FDMI, MIS-D, 75/100, C (hole patterns = 100 x 100 mm and 75 x 75 mm)
• Mounting Options: Mounts to sturdy vertical surfaces. Where applicable, attach to wood stud
• Mfr's part # 45-231-200
• Warranty: Five (5) years
